Digital Link DL3100 Guía de usuario Pagina 147

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 166
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 146
G-1
G
Glossary G
ABAM
A designation for 22 gauge, 110 ohm, plastic insulated, twisted pair Western
Electric cable normally used in central ofÞces.
AIS (Alarm Indication Signal)
An unframed sequence of All Ones normally sent by a DSU/CSU that cannot
maintain the required pulse density in AMI mode or sent by a CSU that has a
loss of signal condition on its data port. The signal is sent to maintain
continuity of transmission and to notify the far-end that a transmission fault
exists on the line. Same as Blue Alarm.
alternate loop code
Used to invert loop codes from U.S. standard code; inverts zeros to ones and
ones to zeros.
AMI (Alternate Mark Inversion)
A line code in which the signal carrying the binary value alternates between
positive and negative polarities.
ANSI (American National Standards Institute)
Coordinates the development of U.S. voluntary national standards in both the
private and public sectors. Standards pertain to programming languages, EDI,
telecommunications and physical properties of diskettes, cartridges and
magnetic tapes.
ASCII (American National Standard Code)
The standard and predominant seven-bit (eight bits with parity) character code
used for data communications and data processing.
asynchronous transmission
Transmission not related to a speciÞc frequency, or to the timing of the
transmission facility.
attenuation
Reduction or loss of signal strength, measured in decibels; opposite of gain.
B
B8ZS (Bipolar 8 Zero Substitution)
A technique used to accommodate the ones density requirements of T1
transmission.
Vista de pagina 146
1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 165 166

Comentarios a estos manuales

Sin comentarios